The release-notes for CML 2.7 beta has been released, but there is no mention of when the regular release will happen. Is there any timeline for when we can expect 2.7 to enter general availability?
I am working on automating lab setup with Terraform and have hit a wall with DNAC-VA configuration. I have figured out how to apply basic configuration to the DNAC-VA using cloud-init on VMware(imitating the launcher). But this leaves something to be...
After quite a lot of troubleshooting I found that the latest IOSvL2 image fails(throws CPUException and resets) when I bring up L3 port-channels with multiple subinterfaces. Where can I report bugs like this?
I have two edges connected to two switches and two routers running VRF lite. The both routers terminate an MPLS circuit and and internet circuit into separate VRFs. There are sub-interfaces for each VRF from the switches and routers towards my edges....
As of version 1.22 Sastre Pro functionality has been added to open-source Sastre. I think this is great and immediately see multiple usecases for both the lab and for certain workflows. Thank you @mareis(and everyone else involved) for making this de...
You have to change SDM template to be able to enable ip routing with the following command:sdm prefer lanbase-routing You can read more about this in this config guide: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release...
The minimum requirements are mostly a recommendation, I believe you will be able to start up with even less - but it will pretty much be unusable. Are you planning to run CML as a VM on the laptop you mention? If so I believe you should be looking in...
You can't set these directly AFAIK. They will all be a result of where your AP is assigned and what settings you select under "network settings" > "Wireless"
Cisco equipment won't support SLPP at all as it is a proprietary protocol. If possible, you will have to handle the SLPP/STP border on the Extreme switches. I suspect that the most robust solution is to convert to using STP throughout your switched n...