hi guys . i have a network with below topology. In the core layer, I want to have redundancy, which means that if the main core switch of my network has a problem, the backup switch will automatically enter the circuit. What method is there?
Hi guys.I have a 2960-48pst-l switch for connecting camera network with mikrotik and cisco and dahwa devices and all of them are on the vlan 1 . But here is a problem. When i connect and disconnect any of these devices such as camera and mikrotik ra...
hi guys.i have a laptop ASUS VivoBook 15 R521JA and the ME3600x-24fs-M switch that i dont know its user, pass . when the below note is showed in start of switch , i'm clicked on pause/break button and the flash of switch initiated and It does not go ...
hi guys.i have a network with below topology: when i want to create trunk port between cbs-350-8t-e-2g and 2960-48pst-l , the point is this the cbs 350 only support ISL trunking protocol and don't support dot1q trunking . and the 2960-48pst don't su...
Hi guys. I have a network with many hubs. And i have timeout sometimes in my network and im showedthis in my 2960 switch this loggs.My network topology is: all of the port of these switches are on vlan 1 .What i doing to solve this problem?
I mean that for enabling hsrp ,we need to command sw(config)#standby , and this command not running in trunk or access port , because we should typing "no switchport" before command "standby" then the hsrp only implemented in layer3 interface.Many t...
thank you so much M02@rt37 the type of my core switch is 3600x-24fs-m and the place of these two core switch is in the different and far a way places but they are connected with fiber link and in layer 2 network . what the method you recommend to me?
