Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi Team, I am new to the Cisco domain. I have been tasked with investigating and configuring an ISR4331 as a voice gateway. We are currently using AudioCodes Voice Gateways and want to include Cisco ISR 4331 as a voice gateway option in our fleet.I h...
Hi,cisco SNR enabled to receive simultaneous call on teams and deskphone ,but when i answer on teams , the deskphone also answeringThanks
Hello over there, Is there any way to register end user Avaya J100 to CUCM?if it is yes, how can I register it?I tried to add it as 3rd Party but not registered.CUCM is v11.5
I have a stack of CP-8841 phones that were handed to me. They have all been reset to factory default. Unfortunately, it does not appear to be listening to port 80 for configuration via WebGUI, so after some research I've looked into configuring it vi...
Hi,I encountered a problem with CUCM SNR not functioning after a previously successful operation. The issue arose following a planned shutdown. To troubleshoot, I established an alternative trunk to a third-party SIP server and attempted to assign th...
Hello All!I'm still learning Cisco Call Manager and my company just acquired a new office building and I need to add 20+ new phones and extensions. I've created the device pool, but I was wondering if there's a way to add the new phones along with ex...
I had to replace an informacast analog adaptor that connected to a Bogan overhead paging system. I was recommended to use ATA 191 as the replacement. This is a ATA191-K9 enterprise device, not MPP.I configured the device in cucm and when analog phone...
Currently looking into an issue w/ some new 8861 that won't register successfully to a CUCM running 10.5. CUCM has other 8861s that are registered successfully and has a device default firmware of 12.8. The new 8861s shipped with newer firmware(14....
In Jabber 14.3 under Settings/Accounts users can no longer enter credentials. The TFTP server information is displayed for Instant Messaging and Phone services. Where is this information being pulled from if we don't enter it there anymore?
Hello, can somebody tell me if (and how) Cisco 8945 can work with 2 different PBX? Here is my XML file that works fine with just one PBX, but I need it to work with 2. Basically I want Line 1 to be serviced by PBX1 and Line 2 by PBX2. Tried putting t...
Please do not say it should be blank. That does not work. I need to get into admin advanced but cannot figure out what the password is supposed to be.
Hi All,For incoming FXO calls auto attendant does not respond to digit entry from certain provider, whereas recognize digit entries from other providers normally and the forwarded the entered extension normally.Call flow:PSTN caller – FXO – (Router t...
I bought an 8865 to use with Zoom Phone. I tried connecting to the WIFI and it wouldn't connect. I tried connecting it to my cell phone as a hot spot but that didn't work either. Am I doing something wrong?
Hello, I have a Cisco Router 2911/K9 that has EVM-HD-8FXS/DID Card installed with EM-HDA-3FXS/4FXO and EM-HDA-6FXO daughtercards. Now i want to upgrade my router and as i followed the cisco replacement path i found that C8200-1N-4T is the replaceme...
Hello,I have an issue on my network. in our network we have Cisco 2811 (ADVENTERPRISEK9-M, Version 15.1(3)) on our brach side with FXS module. sometimes when i try do make connection in my network with this branch i can dial the branch number but on ...
