For those familiar with Cisco DNA I re-added at network setting an AAA server. This was to progress a TAC case I had hoped to target one particular device. Unfortunately it not only target that device. It also initiated a configuration change on the...
Forum Posts
Resolved! NCGR10087 Error in DNA Center
Hi Everyone,Does anyone know what is causing this error in DNA Center?NCGR10087: Site cannot be updated as site or its parent has network profile associations.I cannot move a Buildng from one Area to another. Although when I create a completely new A...
We are in the final stages of migrating our network device management from Prime to DNA Center. I have found equivalent functions within DNAC for just about everything we did in Prime, with one big exception. I was in the habit of using Prime's com...
Hello,I'm having issues migrating maps with access point locations from Cisco Prime 3.10.1 and DNAC 2.2.3.6 using the Prime Data Migration Tool. The sync is successful between Prime and DNAC but when I look in DNAC for the the particular map I moved ...
Hello, i work at a university and we run all cisco switches and routers for the university in our datacenter on prem. Recently we had a bad storm that took caused a power surge and took out 1 switch. We managed to recover by rebooting the switch, how...
Hello All,We're running into an issue here with DNA Center Device Replacement for Industrial Ethernet switches. These switches are extended nodes as part of a larger SDA fabric, though I'm not sure how much of a factor that is.The problem is that whe...
Hi all,Is it possible to adjust the Client Connectivity Score values? For instance, adjust the RSSI from the default -72dBm to -67dBm.Thanks. Kind regards,Vasco
Has anyone figured out a way to stop a task in progress within DNA center? i.e. deploying software image to switch across WAN circuit and realize this should be done during non business hours to preserve bandwidth.
I can either add a new physical switch to an existing stack in dnac and then do a resync or provision on the cli of the switch in advance of adding the new member and then resync in dnac. At which point dnac becomes aware that stack has a new member....
Hi. After upgrading DNA Center to 2.1.2.7, there is a discrepancy between the access interface configuration for my switches. After provisioning a LAN Automated switch and making it fabric enabled, I would expect the following configuration on my acc...
How can I configure device-tracking attach-policy IPDT_POLICY on the all ports?Or it isn't work with netflow config?
Helloi have a question, is it best practice for both fusion router and Border node in stacks ? because in document how to configure fusion router for the border and fusion are different logic thank you
Hello Cisco community, I have a question regarding the DNA Center which is the following : If a switch is managed by DNAC through NETCONF, when I change the switche's configuration manually through CLI (for erxample adding a VLAN), can I use the "res...
Good morning all,Can you use DNAC to archive your network devices configurations? Hope you all are staying safe.
Hi Gents, Can I start the cisco SDA setup with a single DNAC DN2-HW-APL node for production and add the remaining 2xDN2-HW-APL server after the installation is complete, maybe after a few months ? and is there any limitation (some functions need a f...
