12-19-2019 10:53 PM
Hello,
I have an ASR9K running on version 6.5.3
I tried to connect a link between the ODF transmission and port 1G on ASR 1K and the port remain down.
The port configuration:
interface GigabitEthernet0/1/0/17
ipv6 enable
!
interface GigabitEthernet0/1/0/17.3
ipv4 address 41.207.191.170 255.255.255.252
encapsulation dot1q 3
!
interface GigabitEthernet0/1/0/17.33
ipv4 address 41.78.137.225 255.255.255.252
encapsulation dot1q 33
I use the SFP GLC-LH-SMD in first After I tried with EX and ZX but didn't work. I switched the fiber no resulet.
Can you please assist what will be the issue exactly.
Regards,
12-20-2019 02:16 AM
is this point to point link or Internal termination Link?
If this is a Point to Point link required to change tail end change the polarity - look below document for reference :
https://www.flukenetworks.com/blog/cabling-chronicles/b-c-s-fiber-polarity
12-20-2019 12:06 PM
Can you get show controller GigabitEthernet0/1/0/17 all?
Specifically looking for any flags on the link and the light levels for Tx and Rx.
Sam
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide