cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1093
Views
0
Helpful
6
Replies

Wireless LAN Connection Configuration

ja.patrick1080
Level 1
Level 1

Need Basic Wireless LAN Connection Configuration Example

2 Accepted Solutions

Accepted Solutions

Hi

This link provide WLC configuration examples

http://www.cisco.com/c/en/us/support/wireless/5500-series-wireless-controllers/products-configuration-examples-list.html

Refer config guides if you need step by step guide for all features configurations

HTH

Rasika

*** Pls rate all useful responses ***

View solution in original post

Hey James,

 

Please go through the below links which can help you on best practices for basic WLC configurations.

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/68005-wlan-connect.html

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/116584-configure-wirelesslan-00.html

View solution in original post

6 Replies 6

ja.patrick1080
Level 1
Level 1

any update
 

Hi

This link provide WLC configuration examples

http://www.cisco.com/c/en/us/support/wireless/5500-series-wireless-controllers/products-configuration-examples-list.html

Refer config guides if you need step by step guide for all features configurations

HTH

Rasika

*** Pls rate all useful responses ***

Hi Everyone,

I have a scenario in which WLC 2504 is connected to Core switch 4507R+E.and access switches are connected to Core switch as well. In these access switches Access points AIR-CAP702I-A-K9.

My question is as follows:

I want to use vlan 104 for office employes with SSID OFFICE-EMPLOYES

I want to use vlan 103 for guest with SSID Office-Guests

Below is what i have configured on core switch 

(config)#interface xx

(config)#description xxx

(config)#switchport mode trunk

(config)#switchport trunk allowed vlan 103,104

Below is what i have configured on access switches

(config)#interface xx

(config)#swithcport mode access

(config)#swithcport access vlan 104

If i am configuring trunk port on access switches and allowing both vlan's 103 & 104 access points are not joining controller.

Right now management IP is from vlan 104 and all access points and clients are getting ip from 104 vlan.

What shall i do in this scenario.I want to use segregate the guest and office employe traffic.

It would be great if any one can help me.

Moin Ilyas
Level 4
Level 4

http://www.cisco.com/c/en/us/tech/wireless-2f-mobility/wireless-lan-wlan/tech-configuration-examples-list.html

Hope that helps.

gohussai
Level 4
Level 4

Check the link below ,example with Cisco best practice.

 

 

http://www.cisco.com/c/en/us/td/docs/wireless/technology/wlc/82463-wlc-config-best-practice.html

Hey James,

 

Please go through the below links which can help you on best practices for basic WLC configurations.

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/68005-wlan-connect.html

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/116584-configure-wirelesslan-00.html

Review Cisco Networking for a $25 gift card