About husamabobakr

husamabobakr · 06-23-2021

Dear team, One of the Customer is asking for the following test scenario for NRFUThe customer wants to unplug the power Cables from all three APIC nodes instead of graceful Shutdown at each site and wants to check if it works fine aft...

husamabobakr · 06-10-2021

Dear Cisco team, One of Customer is asking for following test scenario for NRFUThe customer wants to unplug the power Cables from all three APIC nodes instead of graceful Shutdown at each site and wants to check if it works fine after ...

husamabobakr · 11-13-2019

Dears, i have one question regarding native vlan. i have two switch as below :SW1inter f0/1swicht port mode trunkswitch port trunk allow vlan 5-20switch port trunk native vlan 10 SW2inter f0/1swicht port mode trunkswitch port trunk allow vlan 5-20swi...

husamabobakr · 10-29-2019

Dear Community Support,i have on question about APIC-EM ACL. Analysis tool.which two values are needed to run the APIC-EM ACL Analysis tool?is it destination address and source address.

husamabobakr · 11-13-2019

Thanks Mr, Jon Marshall

husamabobakr · 11-13-2019

Thanks Mr, Joseph W.

husamabobakr · 11-13-2019

Thanks a lot Mr,Dan Lukes :)

husamabobakr · 10-29-2019

Thanks

husamabobakr · 10-29-2019

what if i got question like below:which two values are needed to run the APIC-EM ACL Analysis tool?1. destination ip address.2. destination port3. source ip address4. source port5. protocolwhat is the best choice would be ( only two choose)

Member Since	‎10-29-2019 03:31 AM
Date Last Visited	‎11-06-2023 11:27 PM
Posts	10

User Statistics

User Activity

APIC

APIC

Untagged

APIC-EM ACL Analysis tool

Re: Untagged

Re: Untagged

Re: Untagged

Re: APIC-EM ACL Analysis tool

Re: APIC-EM ACL Analysis tool