Hi,
Has anyone had issues where you are running FTD with AnyConnect (secureclient) with Posture (DAP) enabled and some computers are sending the attribute endpoint.am=xxx and others aren't?
I have several devices not sending the anti-malware attrib...
Hello,
Just found something odd.
Custom profile for a few printers.
I then added them to a logical profile.
Created a policy for them.
Tested the printers, they get the profiled.
They show up on the logical profile, I can see all MAC addresses...
Hi,I was looking for design recommendations for a particular design scenario.I am working on an E/W FW with IPS and I am looking for a recommendation on how to setup the IPS Variable set - $HOME_NET. I have about 50 Interfaces and 90% of the traffic ...
I have a DAP policy looking for MS Defender, MS Defender ATP, SentinelOne, Cisco AMP, Cortex, VMware Carbon Black, and others.
They are all listed here https://www.cisco.com/c/en/us/td/docs/security/vpn_client/anyconnect/secure-firewall-posture/su...
Hi Marvin,
CSCwe44571 says the problem is fixed on 7.2.5.1. I had the issue and I had TAC on the line, we managed to save some disk space with the same commands + deleting some old PCAP files.
NOTE: I upgraded the FMCv to 7.2.5.1 and I still have i...
You are not just changing the FMC or FTD management IP address, you are deploying a new FMC and you need to move the FTD to this new FMC.
As per today, I am not aware of a "simple method". Here is what I have done in the past: (assuming you're doing...
One last update.If you need to change the management IP address from the FMC, but you dont want to lose the configuration on the FTD you need to visit the FMC and go to the FTD device page and disable management of it. Then go to the FTD device and c...