Good morning,My manager is trying to register for access to the SNTC portal but is having issues. I believe I have all relevant information - CCOID, email, contract number, serial number - but who can help us with this?Thank you,Leonard
Good morning, I have been trying to register for an SNTC account, but when I try to verify with a serial and contract number, I keep getting the following message:We encountered an error while processing your request. Please refresh this page or try ...
Hi,I am having a problem with a remote 871 router, periodically it goes down for some unknown reason. There is nobody on site with technical experience that can troubleshoot it once the site drops. Below is a section of the router log with entries ...
Hi,I just purchased one of each of the above, both with 1ea WIC 1DSU-T1, and would like to connect them directly to each other in a lab scenario. Do I need to have an RJ48 cable or will an RJ45 work? I have them connected now, but they are not seei...
Hi,I am having trouble getting some multicast traffic across a link. I have a 3750G setup, with IP routing and IP multicast routing, between two laptops. This will eventually sit between two networks that cannot be physically connected to each othe...
After a meeting with our Cisco rep and a couple of other Cisco employees with familiarity of the SNTC/CSPC environments, it was suggested that we shutdown the VM and let it sit for a few minutes, then restart it and not touch it for 30mins. That wor...
Should we assume since there hasn't been any response to this that Cisco provided the CLI as a feature, and even documented how to use it, but don't actually want people to use it?
We are having the same issue and I am wondering if this is by design. But if it is by design, then why make it available and publish a PDF to administer it via the CLI. We're nerds and we want our CLI.
I assume you are going to upgrade the new switch to 15 so it's at the same rev? If the 15 switch is using a .bin file, you can just copy the file from flash to your tftp server and copy it to the new switch. You could probably just copy the config ...