Hi, After resetting password of Exsi host from the GUI were able to login with the new password but after few days when i tried new password/old password with both were not able to login. Can someone suggest the steps to recover root password of exsi...
Forum Posts
Our blade sees the LUN, but when attempting to boot ESXi (legacy bios) I get:Has anyone had experience booting to ESXi? I'm sure I'm missing something easy.Thanks in advance.
Is anyone able to advise if 1 or 2 CPUs are required in B200 M5 to run 2 x NVME disks in the front bays?(C220 M5 and C240 M5 require 2 x CPUs to run 2 x NVME, but i can't find anything specific for B200 M5... is it the same for these?)Thanks!
Resolved! UCS B200 M5 Boot From SAN-NIC Errors
Long story short, we have moved some of our M5 blades from one chassis to another. 2 of the 3 are running fine, but the 3rd is throwing NIC errors shown below:These blades are boot from SAN so I'm assuming this is a zoning issue. However, I'm not we...
NO LONGER REQUIRED
I'm doing UCS servers firmware upgrade. and all my servers are siting in pending activities.I'm using below cmdlet to acknowledge server one by one 2 years back but not working now.Set-UcsLsmaintAck -ServiceProfile $servername -AdminState trigger-imm...
I am trying to get the Rails for 2 C-240 servers removed from a rack but cannot figure out how to get them to release. I have remove the servers and the rail slide but don't see how to release the locking plates in front and back.Any ideas?
I’m currently trying to scan Cisco UCS devices using Nessus Scanner but I’m keep getting non-authenticated scans. Under the scan results I cannot find the Plugin ID 110095, shows as no data. I was able to scan these devices with authenticated scans b...
Hi, I need your help..A system log as below has occurredI'd like to understand why this issue occurred.I'd also like to know if there is any solution for this. FRU_RAM SEL_FULLNESS: SYSTEM EVENT SENSOR FOR FRU_RAM, FAILURE EVENT
Hello,I have just deployed HX 3.5.2h with VMware ESX (HX-ESXi-6.7U3-15018017-Cisco-Custom-6.7.3.2) on C240M5 AllFlash, and I can see that all nodes in vCenter report: Host TPM attestation alarm. The workaround on VMware's KB says to enable EUEFI secu...
I'm trying to configure our UCS domain to send syslog messages to our syslog server but somehow I can't get it to send any logs. For testing I made two SSH connections to the FI. On the first ssh session I run:ethanalyzer local interface mgmt capture...
i have a ucs blade server running firmware 4.13b and ive been trying to figure out a solution for offline upgrades. if i use scope cimc/firmware update (ftp) i know the update is being done and is not applied until i issue "activate", but i've been t...
To host some VMware VMs that demand very low latency, I want to configure SR-IOV on one or more interfaces of B200-M4/M5 blades. However I can't find any instructions on how to do this. Been searching but the most recent instructions I can find are f...
Hello Folks, I met a strange setup for a LAN Cloud in UCS Manager (3.2.3k) There is a production VLAN with the same name and the same ID, which has been definied both in "Dual Mode", and also in "Fabric A" in the LAN Cloud (don't ask why ) - What wi...
The results from a recent pre-upgrade check are reporting that the "Safeshut Workaround" is "Needed." The comment is, "Contact TAC". I did some research, but I cannot find any substantive information at the Cisco site or elsewhere. I resorted to read...
