Other Network Architecture Subjects

Hey all,A little background info:Our client PC's are connected to a Cisco Catalyst 2950 Switch with a port speed of 10MBPS/Half Duplex. We also have a server connected to this same switch, but the switch port speed for this server is set to 100Mbps/F...

We are about to get up MS Windows Network Load Balancing (WNLB) for a proxy array. The two array cluster members will be in different buildings connect to two different Cat6k switches, separated by a fibre link.WNLB will be set up in "Multicast" mode...

Dear Friends, My requirment is say if remote office is using 10.x.x.x network and HO at remote end is using 10.x.x.x network.Everthing is properly routed so that now remote office is able to work with HO.Now remote office LAN is entirely changing t...

I am trying to create a single ended spvc between a cesm card and a pxm1e, configuring from the pxm1e I am getting an error: "ERR: SPVC is not allowed on this interface (dcmp)" How can I create this virtual connection ?

Hello there,We have 2 Cisco 4506 and they are connect as fallow.The Switch 1 is connected as a trunk on Switch 2, we are in the process of migrating it from Nortel Switches to Cisco, We have the 1 Nortel Main Switch that is connected to the Cisco Swi...

hello,we have a few 2620's running as LNS with VPDN L2TP setup. We can dial in and get assigned IP etc. ping the local LNS, but nothing else. We have recenlty upgraded from 12.2(11)T2 to 12.2(15)T5. Configuration is the same. I noticed between the tw...

Is there any difference between ISC 3.0 Service Provicer and Enterprise release regarding software features?? Is it the same software with a different license only?? Would it be required to reinstall software to upgrade from Enterprise to Service Pr...

I have a Cat4006 Sup-III with the following as a show version:Cisco Internetwork Operating System SoftwareIOS (tm) Catalyst 4000 L3 Switch Software (cat4000-IS-M), Version 12.1(8a)EW1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)TAC Support: http://www.ci...

Hi.I'm configuring one old 1603, when I insert the command: ip nat inside I obtain: % Invalid input detected at '^' marker.What is the problem??Regards.

I am migrating a network from EIGRP to OSPF. I have configured OSPF with an area 0 and non-zero areas hanging from it. Two via virtual links. Each area has 6 routers, two of them are the ABR's to area 0 (A and B chain). I have turned off EIGRP on ...

The timestamp in the report generated by the RME syslog analysis is not in sync with wth the CSCOpx\log\syslog.log file. NTP is enabled on the network. The timestamp on all the Cisco devices including the CW2K server is in sync wth the timestamp in t...

this is a peculiar problem we have WAN connection between two routers and we are able to ping between the routers. However when we do a traceroute from one router to the next router's either serial or ethernet address it shows the trace unreachable *...

Is it possible to configure Ciscoworks to use an external database such as Securid or Cisco ACs database for authentication