About Ditter

Ditter · 05-12-2024

Hi to all,i am facing the following problem, please refer also to the png attached (i also have some information on the png attached).An IPsec VPN 2811 router tries to establish an IPSec vpn with an FTD. I have setup this config on the lab and i noti...

Ditter · 04-28-2024

Hi to all,i was trying to find why the the vpn between an FTD and a cisco router could not come up and concluded to this:When i create the S2S VPN PtP topology if i just add the protected networks, the tunnel does not come up.For example if behind th...

Ditter · 04-12-2024

Hi to all,i am facing a strange issue with poe devices on a Cat 4500 with SUP7L and the WS-X4648-RJ45V+E card.When we disconnect a poe device from the switch and we plug int again , the device gets in power deny state.And if we plug this device to a...

Ditter · 03-11-2024

Hi ,i have already implemented site to site VPNs for which there was no need for extra licensing.But now i would like to ask if in order to implement Remote Access VPNs do i need extra licenses to buy?And this is true either for SSL or IPSec Remote A...

Ditter · 03-10-2024

Hi to all,i would like to share with you a "worrying" behavior of FMC.To be more specific, i noticed that a week ago , FMC stopped sending emails for some events i had configured it.At the beginning i assumed that it was a problem on the relay agent ...

Ditter · 05-12-2024

Thanks a lot for your help.

Ditter · 05-12-2024

@MHM Cisco World So what do you think about my above point? Is my thought correct about the positioning of the firewall as far as OSPF is concerned? Off course it depends on how the network is configured but as i said the topology is pretty much st...

Ditter · 05-12-2024

The last point is not clear to me. I mean the router marked as Internal at the upper right corner.

Ditter · 05-12-2024

Thanks @MHM Cisco World , as the FTD does not permit VPN traffic to pass through the device , static route should be created in FTD in order to permit traffic to be sent to the appropriate interface where the VPN is created.

Ditter · 05-12-2024

So, as my other 4 backbone routers have created their main adjacency via area 0 via this RFC1918 network (192.168.2.0 network), i will have to remove the FTD from the area 0 and put it in another area , for example the area that covers the main site ...

Member Since	‎07-03-2018 02:53 AM
Date Last Visited	‎05-12-2024 06:01 PM
Posts	267
Total Helpful Votes Received	43

User Statistics

User Activity

FTD Routing question

Creating a S2S VPN - protected networks via IP extended ACL

Catalyst 4500 with SUP7L deny power to poe ports

Do i need anyconnect licenses for Remote Access VPNs

FMC showed a strange behavior

Re: FTD Routing question

Re: FTD Routing question

Re: FTD Routing question

Re: Creating a S2S VPN - protected networks via IP extended ACL

Re: FTD Routing question