FPR2110 with ASA image after re-imaging to FTD

[Ibrahim-Sharif]

Hello All,

We have two Firepower 2110 appliances with the ASA code and I want to re-image the appliances with the FTD code 6.6 or 7 so my question is when I do the re-imaging and add them to the FMC do I need any type of licenses to configure them as HA or no need?

Thanks in advance,

[Rob Ingram · Accepted solution]

@Ibrahim-Sharif 7.0.5 is the recommended version, but I might suggest going with 7.2.3.

High availability (HA) mode is part of the base license (which comes with the appliance), so you don't need to purchase an additional license.

https://www.cisco.com/c/en/us/support/docs/security/firepower-management-center/215838-fmc-and-ftd-smart-license-registration-a.html

[Ibrahim-Sharif]

Hello Rob,

Thank you for your reply and feedback, so if I registered the FMCv in the Smart account then I did add both FPR2110 appliances to the FMC I can configure the HA normally, and no need for any additional license, unless I need more features then I should purchase the license.

Thank you,

Ibrahim