add nwe ip to monitoring in PRTG

[gabriel garciaf]

Hi Community

i have a question, about cisco ISE

to add a ip to monitoring the ISE only is in the CLI?

or i can add the ip in the GUI, i checked the documentation and appear information to add the ip only in the CLI

Thakns 

[Greg Gibbs]

If you are asking about adding the PRTG server as an snmp-server host to monitor ISE using SNMP query/trap, that would be done only from the CLI.

https://www.cisco.com/c/en/us/td/docs/security/ise/3-2/cli_guide/b_ise_CLI_Reference_Guide_32/b_ise_CLIReferenceGuide_32_chapter_011.html#wp2872325278

[gabriel garciaf]

Thak you so much by your commnets  Greg Gibbs i can add the snmp server without problem

[MHM Cisco World]

https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/215521-configure-and-understand-snmp-traps-to-m.html

check this 
thanks 
MHM

[Arne Bier]

I think @gabriel garciaf means that there is no way of seeing the IP address details in the ISE GUI (other than the IP address in Deployment page) - one has to log into the CLI to see the v4 subnet mask, default gw etc.

I agree - it should be a half-day job to code that up and make one summary table (kind of like Context Visibility) to show all the ISE IP Layer Details for the entire deployment. It's a pain to have to log into the CLI of each node to check these things.